Precor Low Impact M9.55 - Manual (Page 16)

page 16
3
Slide the
hood under
the 2 screws
found on the
inboard side
of both
upright
supports.
4
Diagram 11 Secure the
hood.
2
1
13. Attach the hood. Diagram 11. Place the hood over the motor and slide it under
the upper 4 screws (see Diagram 11 #1) and over the 2 lower screws (1 found
on each side) of both upright supports.
As you lower the hood, slide the hood under the washers and onto the screws (2 in
the front, 1 on either side of the treadmill). See Diagram 11, #2 and #3. Retighten the
screws that you loosened in step 4.
Be sure that the hood is sandwiched be-
tween the base assembly and the washers. The washers must be on the
outside of the hood. Tighten the screws securely using the hex key provided.
2 1
Diagram 12 Level
the
unit.
14. The M9.55 has adjustable rear feet. Check to make sure that the running surface
is level (use a bubble level as shown in Diagram 12). If the treadmill is placed on
a slightly, uneven surface, adjusting the rear feet can help, but will not compen-
sate for extremely uneven surfaces.
CAUTION: Do not overtighten the screws
or you may inadvertently cause stress
cracks in the plastic hood.