Precor Low Impact M9.55 User Manual
Page 18
page 18
Checking the Alignment of the Running Belt
The belt is aligned at the factory before shipment. However, during shipment or by
using the treadmill on an uneven surface, the belt might move off center. Proper belt
alignment is important because it allows the belt to remain centered and assures
smooth operation.
Follow these steps to check the alignment:
1.
The treadmill has adjustable rear feet. Check to make sure that the running
surface is level (refer to steps 14 - 16 on the previous pages). If the treadmill is
placed on a slightly uneven surface, adjusting the rear feet can help, but will not
compensate for extremely uneven surfaces.
2.
Locate the ON/OFF (I/O) switch at the front of the treadmill and turn the unit ON.
3.
Stand beside the treadmill and press Quick Start.
4.
If necessary, enter the password: Incline
▼
, Speed
▼
, Speed
▲
.
The running belt starts automatically after the message, “
Belt Starting 3, 2, 1,...”
appears.
5.
Continue standing next to the treadmill and hold down the Speed
▲
key until the
display shows a speed of 3 miles per hour (5 kph).
6.
Walk around to the rear of the unit and observe the belt for a few minutes as it
moves.
If the running belt,...
Then,...
tracks centered on the running surface
the belt is functioning correctly
(evenly distributed between the side rails)
and no adjustment is necessary.
runs or drifts off center
you need to adjust the belt; see
Aligning the Running Belt, page 42.
Important: If you notice that the belt needs alignment, make the adjustments at
once. Failure to do so might cause the belt to tear or fray which is not covered by
the Precor limited warranty.
7.
To stop the running belt, press the red Stop button.
If the belt is functioning correctly, the M9.55 treadmill is ready to use.
CAUTION: Do not walk on the running belt
during this procedure.
CAUTION: If you hear any chafing or
the running belt appears to be getting
damaged, stop the running belt immedi-
ately by pressing the STOP key. Contact
Customer Support.