Philips DTR 2530/05 - Manual (Page 8)

9 Getting started
ENGLISH
Connect 3.2
Danger
Risk of electric shock!
Make sure all the devices are disconnected from
the mains before making any connections.
SCART connection
Connect the aerial cable from the wall
socket to the RF IN socket at the rear of
the Digital Terrestrial Receiver.
Connect the RF OUT socket at the rear
of the Digital Terrestrial Receiver to the RF
input of your TV set using a coaxial cable.
Connect the supplied scart cable to the
scart input of the TV set and to the TV
scart socket at the rear of the Digital
Terrestrial Receiver.
Plug your Digital Terrestrial Receiver to the
mains using the supplied power adaptor.
Close the battery compartment.
Note
Point the remote control directly at the remote
sensor on the front panel and select the desired
function.
Caution
Do not mix batteries or keep them in the remote
control for long periods of time without use.
Batteries must not be disposed of with your
household waste but to a local separate battery
collection system.
Do not dispose of batteries in a fi re.
Insert the Smart card
To insert the smart card:
Open the smart card door on the right •
side of the front panel.
Insert the smart card into the smart card
•
slot as far as it will go. The end of the card
will be visible from outside the slot.
Warning
Insert the Smart card with the chip facing down.