Philips DTR 2530/05 - Manual (Page 9)

Getting started 10
Install 3.3
Press B on the remote control and wait a few
seconds to switch the receiver on.
The receiver is on: the LED is green.
The receiver is in standby mode: the LED is red.
During a software loading: the LED is blinking.
At the fi rst installation, the First Time
Installation window appears:
Highlight the Country fi eld using the arrow
key .
Select the desired language using the arrow
key or .
Note
Read the information messages displayed on
the screen. They will help you to set the correct
values.
Highlight Postcode using the arrow key .
Press OK and enter your postcode.
Then successively set the desired values. In
doing so, observe the following:
By using the arrow key • or , you switch
between the individual setting possibilities.
By using the arrow key
• or , you change
the displayed values.
•
Then highlight the OK fi eld using the arrow
key , and press OK.
The Automatic Search window is displayed:
If desired, change the values for the Start
and End Frequency using the arrow key
or .
Note
The displayed values for the Start and End
Frequency can normally be maintained.
Using the arrow key or , you defi ne the
channels to be searched for: All channels or
channels that are Free to air only.
Then highlight the OK fi eld using the arrow
key , and press OK to start the channel
search.
The window displayed provides information on
the progress of the channel search.
Note:
By pressing EXIT, you can stop the scan mode
at any time.