Panasonic SX-KN2600 - Manual (Page 129)

Part VI Disk Drive (KN2400)
129
QQTG0692
D
isk D
riv
e (
K
N
2
400
)
• Note that this procedure clears any data which
is currently stored on the disk.
1. Select the type of format (2DD or 2HD).
• Be sure to select the type which is the same
as your disk type.
• If the type is automatically detected, the dis-
play changes directly to the following display,
without showing the type select display.
• The display looks similar to the following.
• If you wish to select the type again, use the
PAGE button to access the PAGE 2/2 display.
2. Press the YES button to format the disk, or
press the NO button to cancel the format.
• When the YES button is pressed, disk format
begins. After about 1–2 minutes, formatting is
completed and DISK NAMING display is
shown.
3. Use the buttons below the display to assign a
name.
• Set the character input position with the POSI-
TION buttons, select the characters with the
alphanumeric buttons and repeat name
assignment.
• Switch from upper to lower case letters with
the ABC, abc button.
• Press the INS button to enter a space at the
cursor position.
• Press the DEL button to erase the character at
the cursor position.
• Press the CLR button to erase the entire
name.
• Press the →← button to center the name.
4. Press the OK button.
11_Part VI.fm 129 ページ ２００３年２月５日 水曜日 午後２時４３分