Panasonic SX-KN2600 - Manual (Page 81)

Part IV Sequencer
81
QQTG0692
Se
qu
en
ce
r
Sequencer Play
Play back your recorded performance.
1. Press the SEQUENCER PLAY button to turn
it on.
• The display looks similar to the following.
2. After pressing the SONG button, use the
SONG
∧
and
∨
buttons to select a song num-
ber for playback.
3. Use the balance buttons below the display to
show “PLAY” above the track numbers you
wish to have played back.
• Highlighted track numbers indicate tracks that
are already recorded. Only highlighted track
numbers can be selected for playback.
• You can select two or more tracks to play back
at one time.
4. Press the SEQUENCER RESET (FILL IN 1)
button.
• The SEQUENCER returns to the beginning of
the song and the beginning panel settings are
recalled.
5. If you want to playback a song starting from a
point other than the first measure, use the
MEAS
∧
and
∨
buttons to specify the measure
number.
• “MEASURE=” indicates the current measure
number.
6. Press the START/STOP button.
• The recorded performance is played back
from the specified measure.
• When playback is begun from a measure in
which an INTRO, COUNT INTRO, FILL IN or
ENDING is recorded, the corresponding func-
tion does not work.
• You can press the MIXER button and modify
the settings for each part.
• For information about LYRICS, refer to page
123.
7. To stop playback, press the START/STOP
button.
• If the START/STOP button is pressed again,
playback will continue from the point it was
interrupted.
8. When you are finished playing back your per-
formance, press the SEQUENCER PLAY but-
ton to turn it off.
EASY REC PLAY
SEQUENCER
If a rhythm progression has been recorded in
the RHYTHM (RHY) part, the MEASURE dis-
play used in the STEP RECORD and EDIT
displays conforms to the time signature data
stored in the RHYTHM part.
Adjusting the playback tempo
Even with a song having recorded tempo data, you can use TEMPO/PROGRAM or TAP TEMPO to
adjust the tempo to your liking.
• When the tempo is changed, all the tempo data of that song is automatically changed by the same
ratio. Accordingly, even in song data in which tempo change data is stored, a single adjustment of
the tempo produces a natural-sounding playback.
• To return to the original tempo, while the song is stopped press the SEQUENCER RESET button.
Note that the tempo change is also canceled when you switch to another song or load a new song.
• The adjusted tempo is canceled when you begin the recording procedure and the original tempo
data will be recorded.
09_Part IV.fm 81 ページ ２００３年２月５日 水曜日 午後１時３４分