Panasonic AJ-HD130DCP - Manual (Page 12)

12
STOP mode
L- cassette ONLY
POWER
ON
OFF
AUDIO SELECT
AUDIO OUT SEL
INPUT
ANALOG
PULL
FOR VAR
CH 3-4
720 P CH 1·2 CH 3·4
CH 1 REC CH 2
CH 3 CH 4
CH1
ST
CH2
METER
TAPE PAUSE/STILL SEARCH FF STOP REW PLAY REC
EJECT
LOCAL
OFF ON
REC INHIBIT
REMOTE
MENU
COUNTER
RESET
EE SET s DATA r MODE DOWN MENU UP PAGE
1
L- cassette ONLY
POWER
ON
OFF
AUDIO SELECT
AUDIO OUT SEL
INPUT
ANALOG
PULL
FOR VAR
CH 3-4
720 P CH 1·2 CH 3·4
CH 1 REC CH 2
CH 3 CH 4
CH1
ST
CH2
METER
TAPE PAUSE/STILL SEARCH FF STOP REW PLAY REC
EJECT
LOCAL
OFF ON
REC INHIBIT
REMOTE
MENU
COUNTER
RESET
EE SET s DATA r MODE DOWN MENU UP PAGE
Operation
<Caution concerning STILL TIMER setting>
The cumulative standby time in the same places on
the tape lengthens when the same parts of the same
tape are used repeatedly. To protect the tape, make
the standby time in the same place as short as
possible.
Turning on the power and
inserting the cassette
1 2
3
Turn on the power.
1
Press the STOP button to set the VTR to the
STOP mode.
The STOP button lights, and the tape stops
traveling.
O When the time set by setup menu item No.400
(STILL TIMER) has elapsed, the tape
protection mode is established in order to
protect the tape. When the STOP, REW, FF
or PLAY button is pressed, the VTR is set to
the corresponding mode.
1
Insert the cassette tape.
Insert the tape into its prescribed position without
forcing it into place.
2
Check that the STOP lamp has lighted.
When the tape is inserted, the cylinder starts
rotating automatically, the tape is loaded, and the
VTR is set to the STOP mode.
3
<Note>
When “ON” has been selected as the setup menu
item No.104 setting, the STOP button will flash if the
reference video signal is not input.
Before operating the VTR, check that the equipment
has been connected correctly.
The VTR must be installed on a level surface for
operation.