Panasonic AJ-HD130DCP - Manual (Page 18)

18
<Notes>
O
When the drop frame time code is read, the colon
between the seconds and frames changes to a
period.
O
If the time code signal is missing, it is automatically
compensated for by the CTL signal.
What is displayed is shown below.
T 2 R 00 : 07 : 04 : 24
In the case of a drop frame, the colon
between the seconds and frames changes
to a period.
Superimposed display
Time Code & User’s Bit
Setting the user’s bit
Set the VTR to the menu mode.
(By setting the LOCAL/MENU/REMOTE switch to
the MENU position.)
1
Select the setup menu item No.531 (UB
PRESET) setting.
The remaining steps are the same as for
setting the time code.
2
Time code/user’s bit playback
Set the VTR to the STOP mode.
1
Set TC or UB using the COUNTER button.
TC : The time code is displayed.
UB : The user’s bit is displayed.
O
When the time code can no longer be read, it
is interpolated using the CTL signal.
2
Press the PLAY button.
Playback is started, and the time code appears
on the display.
If “ON” has been selected as the setup menu
item No.005 setting, the time code value is
superimposed onto the video signals which are
output from the VIDEO OUT2 connector.
3
An asterisk ( 2 ) appears when
the time code signal is missing.
TC 00 : 07 : 04 : 24
UB
In the case of a drop frame, the colon
between the seconds and frames changes
to a period.
Counter display
The display flashes when the
time code signal is missing.