Panasonic AJ-HD130DCP - Manual (Page 9)

9
Parts and Their Functions
M
TAPE/EE switch
This is used to select the signals to be output
during stop, fast forwarding or rewinding.
TAPE : The signals played back from the tape are
output.
EE : The HD SDI signals are output as the video
signals, and the signals selected by setup
menu item No.700 are output as the audio
signals.
<Note>
While the switch setting is being changed, the
picture and sound may be disturbed.
N
COUNTER button
This is used to select what appears on the counter
display. Each time it is pressed, what is to appear
on the display changes in the following sequence:
CTL
5
TC
5
UB
5
r
5
CTL.
CTL: The tape timer (control signal) is displayed.
TC : The time code is displayed.
UB : The user’s bit is displayed.
r
: The remaining tape and total tape length are
displayed in minute increments.
Example: [r30-46]
Remaining tape: 30 minutes; total tape length:
46 minutes
O
RESET button
When this is pressed in the CTL mode, the counter
display is set to 0 (reset).
P
REC INHIBIT switch
This is used to permit or inhibit recording on the
cassette tape.
ON : Recording on the cassette tape is inhibited.
The REC INHIBIT lamp on the display lights.
OFF: Recording on the cassette tape is permitted
provided that the cassette’s accidental erasure
prevention tab is set to the recording enable
status.
Front panel