Panasonic KX-TG2584S - Manual (Page 82)

82
“ Troubleshooting
Problem
The cordless handset does
not display the caller’s name
and/or phone number.
The cordless handset
display exits the Caller List
or directory.
When a second call is
received during a
conversation, the cordless
handset does not display the
new caller’s name and/or
phone number.
You cannot page the base
unit.
You cannot redial by
pressing
(REDIAL/PAUSE) .
Cause and Remedy
≥ You need to subscribe to a Caller ID
service.
≥ Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
≥ Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
≥ Telephone line noise may be affecting
the Caller ID information.
≥ Do not pause for over 60 seconds while
searching.
≥ The line mode selection is incorrect.
See page 16.
≥ The caller requested not to send his/her
information. See page 34.
≥ The cordless handset is too far from the
base unit.
≥ The base unit is engaged in an outside
call, viewing the Caller List/directory list
or listening to messages. Try again
later. Wait until “
Base in use ”
disappears.
≥ If the last number dialed was more than
32 digits long, the number will not be
redialed correctly.
≥ The button has a double function as
either redial or pause. It will redial the
last number dialed if pressed at the
outset of a call (p. 29). If another
number has been dialed first, it will
operate as a pause button (p. 58).