Panasonic KX-TG2584S - Manual (Page 86)

“ Troubleshooting
86
Problem
You cannot program items,
such as the dialing mode.
Previously programmed
information is erased.
“ Recharge battery ” is
displayed on the cordless
handset, “
” flashes or
the unit beeps intermittently.
You charged the battery
fully, but “
Recharge
battery ” is still displayed
and/or “ ” continues to
flash.
If you cannot solve your
problem
Cause and Remedy
≥ Programming is not possible while the
unit is in the talk, speakerphone or
intercom mode, when viewing the Caller
List/directory list, or while the answering
system is in use.
≥ Do not pause for over 60 seconds while
programming.
≥ Move closer to the base unit, if you use
the cordless handset.
≥ Make sure that the unit is not being
used.
≥ If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
≥ Charge the battery fully (p. 11).
≥ Clean the charge contacts and charge
again (p. 12).
≥ Install a new battery (p. 77).
≥ Call our customer call center at
1-800-211-PANA(7262).
≥ Panasonic’s e-mail address for
customer inquiries:
[email protected]
for customers in the USA or Puerto Rico
ONLY