Panasonic PT-DW90XE - Manual (Page 55)

PICTURE menu
ENGLISH -
55
Settings
COLOR TEMPERATURE
You can adjust the white balance of the projected
image.
Press ▲▼ to select [COLOR 1 )
TEMPERATURE].
Press ◄► or <ENTER> button.
2 )
The [COLOR TEMPERATURE] individual z
adjustment screen will be displayed.
Press ◄► to switch [COLOR 3 )
TEMPERATURE].
The setting will change as follows each time z
◄► is pressed.
DEFAULT Û USER1 USER2
9300K 3200K
[DEFAULT] cannot be selected when the : Û
[PICTRUE MODE] has been set to [USER] or
[DICOM SIM.].
Note
When any setting other than [OFF] has been selected z
for [COLOR MATCHING] ( Æ page 69), the [COLOR
TEMPERATURE] setting is fixed to [USER1].
The value of color temperature is for reference only. z
To further adjust toward the
J
desired white balance
Select [USER1] or [USER2] in Step 3). 4 )
Press <ENTER> button. 5 )
The [COLOR TEMPERATURE] screen will be z
displayed.
Press ▲▼ to select [WHITE 6 )
BALANCE].
Press <ENTER> button.
7 )
The [WHITE BALANCE] screen will be z
displayed.
Press ▲▼ to select [WHITE 8 )
BALANCE HIGH] or [WHITE
BALANCE LOW].
Press <ENTER> button.
9 )
The [WHITE BALANCE HIGH (or LOW)] z
screen will be displayed.
Press ▲▼ to select [RED], [GREEN] 10 )
or [BLUE].
Press ◄► to adjust the level. 11 )
Item Operation Adjustment
Adjustment
range
RED
Press ►. Deepens red.
Maximum
value
HIGH : 255
LOW : 127
Minimum
value
HIGH : 0
LOW :
-127
Default
HIGH : 255
LOW : 0
Press ◄. Weakens red.
GREEN
Press ►. Deepens green.
Press ◄. Weakens green.
BLUE
Press ►. Deepens blue.
Press ◄. Weakens blue.
Note
All colors will not be displayed properly unless adequate z
adjustment is made. If the adjustment does not look
suitable, you can press <DEFAULT> button to return the
setting for the selected item only to the factory default
setting.
The [COLOR TEMPERATURE] cannot be adjusted z
for the internal test pattern ( Æ page 89). Be sure to
project the input signal when adjusting the [COLOR
TEMPERATURE].
Changing the name of [USER 1] J
or [USER 2]
Select [USER1] or [USER2] in step 3). 1.
Press <ENTER> button. 2.
The [COLOR TEMPERATURE] screen will be z
displayed.
Press ▲▼ to select [COLOR 3.
TEMPERATURE NAME CHANGE].
Press <ENTER> button.
4.
The [COLOR TEMPERATURE NAME z
CHANGE] screen will be displayed.
(in units of 100K)
COLOR TEMPERATURE NAME CHANGE