Panasonic PT-DW90XE - Manual (Page 42)

Projecting
42
- ENGLISH
Basic Operation
Projecting
Check the connections of the peripheral devices, installation of the projection lens ( Æ page 38), and connection
of the power cord ( Æ page 39) and switch on the power ( Æ page 40) to start the projector. Select the input signal
and adjust the image.
Selecting the input signal
Select an input signal.
The image selected with <INPUT SELECT> button is
projected. ( Æ page 47)
Attention
Images may not be projected properly depending on the z
connected device and DVD, video tape, etc. to be played.
Select a system format that is suitable for the input signal
using the [SYSTEM SELECTOR] in the [PICTURE] menu
( Æ page 58).
Check the aspect ratios of the screen and the image and z
select the optimum aspect ratio using [ASPECT] in the
[PICTURE] menu ( Æ page 59).
How to adjust the focus,
zoom and shift
Use the Lens Shift, Zoom, and Focus controls to
properly frame the image on the screen.
At the projector
J
Press <LENS> button on the control 1 )
panel.
Pressing the button changes the setup screen z
in the order of [FOCUS], [ZOOM] and [SHIFT].
Press ▲▼◄► to select an item and 2 )
adjust it.
Using the remote control
J
Press <LENS> (FOCUS, ZOOM, SHIFT) 1 )
button on the remote control.
Press <FOCUS> button : z
Adjust focus.
Press <ZOOM> button : z
Adjust zoom.
Press <SHIFT> button : z
Adjust focus.
Press ▲▼◄► to select an item and 2 )
adjust it.
Note
Be careful not to catch your fingers between the lens and z
shroud when shifting the lens.
The zoom adjustment menu will be displayed only when z
a lens with zoom function is installed.
When using ET-D75LE5, set the shift to the home z
position.
The adjustment can be performed faster by pressing and z
holding the ▲▼◄► for about 7 seconds or more.
It is recommended that the images are projected z
continuously for at least 30 minutes before the focus is
adjusted.
If the power is turned off during focus or shift adjustment, z
the LENS CALIBRATION must be performed when the
power is turned on next time.
If the main power is turned off during focus adjustment, z
the LENS CALIBRATION will be performed automatically
when the focus is adjusted next time.
If the main power is turned off during shift adjustment, z
“LENS CALIBRATION ERROR” is displayed when the
shift is adjusted next time. Please perform the [LENS
CALIBRATION] from the menu ( Æ page 86)
If “LENS CALIBRATION ERROR” is still displayed after z
the LENS CALIBRATION is performed, ask your dealer
for repair.