Panasonic PT-DW90XE - Manual (Page 82)

PROJECTOR SETUP menu
82
- ENGLISH
Settings
Display the internal test pattern [ALL 9 )
WHITE] on all projectors.
Set [BRIGHTNESS CONTROL GAIN]
10)
of all projectors to 100 %.
Set [BRIGHTNESS CONTROL GAIN]
11)
of the darkest projector to 90 %.
Adjust [BRIGHTNESS CONTROL
12)
GAIN] of the other projectors to that
of the projector that was set to 90 %.
Set [MODE] of [BRIGHTNESS
13)
CONTROL SETUP] of all projectors to
[AUTO] and set [LINK] to [GROUP A].
[APPLY] [BRIGHTNESS CONTROL
14)
SETUP] of all projectors and press
<ENTER> button.
Brightness control will commence. z
Note
The brightness is corrected automatically each time the z
lamps are turned on using the power switch etc.
If the brightness fluctuates significantly or the lamp has z
been replaced, re-adjust the brightness control.
STANDBY MODE
You can select the electrical consumption while in
standby mode.
Press ▲▼ to select [STANDBY MODE]. 1 )
Press ◄► to switch [STANDBY 2 )
MODE].
The setting will change as follows each time z
◄► is pressed.
NORMAL ECO
Note
With [ECO] setting, NETWORK function, RS-232C output z
and some of RS-232C commands are not available.
When switch on the projector, projection will start about
10 seconds late.
SCHEDULE
This sets the command execution schedule for each
day of the week.
How to enable the SCHEDULE
J
function
Press ▲▼ to select [SCHEDULE]. 1 )
Press ◄► to switch [SCHEDULE]. 2 )
The setting will change as follows each time z
◄► is pressed.
ON OFF
Note
If [SCHEDULE] is set to [ON], the setting for [STANDBY z
MODE] is automatically set to [NORMAL] and cannot be
changed. Even if [SCHEDULE] is then set to [OFF] when
in this state, the setting of [STANDBY MODE] remains at
[NORMAL].
How to assign a program
J
With [SCHEDULE] switched to [ON], 1 )
press <ENTER> button.
The [SCHEDULE] screen will be displayed. z
Select and assign program to each day 2 )
of week.
Press ▲▼ to select a day of week and press z
◄► to select a program number.
You can set the program from No.1 to No.7. z
“- - -” indicates that the program number has
not been set yet.
How to set a program
J
You can set up to 16 commands to each program.
On the [SCHEDULE] screen, press ▲▼ 1 )
to select [PROGRAM EDIT].
Press ◄► to select a program number
2 )
to be set and press <ENTER> button.
Press ▲▼ to select a command
3 )
number and press <ENTER> button.
You can change the page using ◄►. z