Panasonic PT-DW90XE - Manual (Page 85)

PROJECTOR SETUP menu
ENGLISH -
85
Settings
NO SIGNAL SHUT-OFF
You can set the timer to switch off the power of the
projector after a certain period of time automatically
when no signal is detected.
Press ▲▼ to select [NO SIGNAL 1 )
SHUT-OFF].
Press ◄► to switch [NO SIGNAL
2 )
SHUT-OFF].
DISABLE
Deactivate the NO SIGNAL
SHUT-OFF.
10MIN. - 90MIN. At intervals of 10 minutes.
REMOTE2 MODE
You can customize the [REMOTE 2 IN] terminal
function.
Press ▲▼ to select [REMOTE2 MODE]. 1 )
Press ◄► to switch [REMOTE2 2 )
MODE].
The setting will change as follows each time z
◄► is pressed.
DEFAULT USER L6500 SERIES
DEFAULT
The pin assignment of the [REMOTE
2 IN] terminal is used as the projector
default setting. ( Æ page 121)
USER
This is used for changing the settings
for the REMOTE2 terminal.
Any settings you make for pins 2
to 8 become valid once you press
<ENTER> button.
L6500
SERIES
Use the setting for L6500-compatible
REMOTE 2 terminal.
FUNCTION BUTTON
You can assign a certain menu function to the
<FUNCTION> button as shortcut.
Press ▲▼ to select [FUNCTION 1 )
BUTTON].
Press <ENTER> button.
2 )
The [FUNCTION BUTTON] screen will be z
displayed.
Press ▲▼ to select a function. 3 )
DISABLE Deactivate the <FUNCTION> button.
P IN P
Changes between OFF/USER1/
USER2/USER3 in P IN P.
( Æ page 88)
SUB
MEMORY
Displays the assigned SUB MEMORY
LIST. ( Æ page 91)
SYSTEM
SELECTOR
Switches [SYSTEM SELECTOR]
options. ( Æ page 58)
SYSTEM
DAYLIGHT
VIEW
Switches [SYSTEM DAYLIGHT
VIEW] options. ( Æ page 56)
FREEZE Freezes the image.
WAVEFORM
MONITOR Û
Displays the waveform of the input
signal.
PT-DZ110XE only : Û
Press <ENTER> button. 4 )
DATE AND TIME
This lets you set the time zone and the current date
and time for the projector’s internal clock.
Setting the TIME ZONE
J
Press ▲▼ to select [DATE AND TIME]. 1 )
Press <ENTER> button. 2 )
Press ▲▼ to select [TIME ZONE]. 3 )
Press ◄► to switch [TIME ZONE]. 4 )
Adjusting the date and time
J
manually
Press ▲▼ to select [DATE AND TIME]. 1 )
Press <ENTER> button. 2 )
Press ▲▼ to select [ADJUST CLOCK]. 3 )