Panasonic AG-HVX200 - Manual (Page 49)

Shooting
49
Interval recording (INTERVAL REC)
With this function, the unit continuously records
frames (1/30 sec.) one at a time with an interval.
The interval can be set with INTERVAL TIME item.
1
Check that the settings given on the
previous page have been established for
the OPERATION TYPE item and recording
format.
2
Select INTERVAL under REC FUNCTION.
(Page 107)
• For menu operations (Page 97)
3
Set the time INTERVAL TIME. (Page 107)
4
Press the START/STOP button.
The unit starts INTERVAL REC operation.
To stop operation, press the among the
operation buttons.
To release the function, either turn off the unit’s
power or select NORMAL under REC FUNCTION.
• The following displays will appear on the left
of the operation status display.
While recording is underway: I-REC lights up.
In temporary standby: I-PAUSE lights up.
While recording is stopped: The “I-” of I-
PAUSE flashes.
However, if the duration selected in step 3 is less
than 2 seconds, I-REC will flash while recording
is underway in accordance with the set time.
• The pre-recording function does not work.
• No sound is recorded.
• All data recorded while this mode is active will
be contained in one file.
• No guarantees are made for the 1394 output
images.
• Operation is not possible even if only one of
the inserted cards is DIR ENTRY NG CARD.
(Page 94)
• After interval recording has started, a
recordable P2 card cannot be used even if it
is inserted into an empty slot.
• The slots for recording in this mode are
indicated by the orange P2 card access lamps.
The slots for recording P2 cards that are
inserted later are indicated by the green P2
card access lamps.
P2
One-frame
recording One-frame
recording One-frame
recording
Time set as
INTERVAL TIME
(Time)
Time set as
INTERVAL TIME
1
Check that the settings given on the
previous page have been established for
the OPERATION TYPE item and recording
format.
2
Select ON under PREREC MODE. (Page 107)
• For menu operations (Page 97)
3
Press the START/STOP button.
Pre-recording starts.
• In the following cases, the pre-recording
function will be canceled, and recording will
be initiated from the respective operation
points.
· When IEEE1394 input recording is initiated
·
When the unit is transferred from the
playback mode to the recording mode
· When interval recording is initiated
· When one-shot recording is initiated
· When loop recording is initiated
• Immediately after switching from the MCR
mode to CAMERA mode, immediately after
turning on the camera-recorder’s power or
immediately after changing the PRE-REC
option setting, it may not be possible to
record the images and sound before the time
mentioned on the previous page has elapsed
even if the recording has been started straight
away.