Panasonic AG-HVX200 - Manual (Page 88)

88
Dubbing (continued)
6
Press the two REC buttons simultaneously.
If you are using the remote control, press the
PLAY button while holding down the REC
button.
Dubbing now starts. When it finishes, it will
automatically stop, and the thumbnail display
will be restored. (To stop dubbing while it is
underway, press the button.)
• When you wish to start dubbing from a point
mid-way along a clip, first play back the
clip, then press the button at the desired
position to pause playback.
COUNTER RESET TITLE
STILL ADV PAUSE STILL ADV
INDEX
Ð V
O L +
STOP INDEX
MULTI/
P-IN-P REC A.DUB
PLAY /REW FF/
ZOOM
REC
7
Hold down the mode button (for 2 or more
seconds) to release dubbing mode.
• In the VCR setting menu, setting the TCG option
in RECORDING SETUP to FREE RUN enables
the timecode used by the clip to be transferred to
the tape.
• In the case of a clip recorded in four channels,
the audio of channels 3 and 4 will not be
transferred during the dubbing process.
• The dubbing IN points may be slightly ahead of
or behind their actual positions.
• If the FORMAT SEL item on the DUBBING
SETUP screen is changed to 1080i/24P,
720P/24P or 720P/24PN after dubbing with the
1080i/60i, 1080i/30P, 720P/60P, 720P/30P or
720P/30PN format, the dubbing IN point may be
delayed for several dozen frames.
• In the case of clips recorded continuously onto
three or more cards, dub the clips on two of
the cards first. After this, stop the dubbing, and
replace the cards with the third and subsequent
cards. Then resume the dubbing. (These steps
are taken because hot swap playback cannot be
performed.)
• In the dubbing mode, even if an attempt is made
to allocate SHOT MARK, INDEX/MEMO or SLOT
SEL to a USER button, the allocated operation
Camera
or
Remote control
will not be executed. However, the allocated
USER button information will be displayed when
the DISP/MODE CHK button is held down.
Digital input/output (P2 card/Tape)
You can perform dubbing with a high image quality
by means of digital signals by using a 1394
cable to connect this unit to a digital video unit
equipped with a 1394 connector.
• Use the MEDIA switch to select the P2 card or
tape ahead of time. (Pages 25 and 29)
1
Connect the digital video equipment to this
unit. (Page 79)
2
Press the unit’s mode button to switch to
the MCR/VCR mode.
VCR
DUB
MCR
PC
CAMERA
• Cancel the thumbnail screen when in MCR
mode.
• Set up the connected equipment for playback
or recording.
• When performing digital dubbing with a second
camera-recorder or other device, a recording
cannot be made unless the signal formats at
the output side and input side are identical.
• When using with the 720P/24PN and
720P/30PN settings, digital output in MCR
mode only is performed. Digital input is not
possible.
• 1394 input images cannot be output from the
COMPONENT OUT terminal.
3
Start playing back in the player.
4
Start recording in the recorder.
• If you are using this unit, press the two REC
buttons at the same time. On the remote
control unit, press the PLAY button while
holding down the REC button.
COUNTER RESET TITLE
STILL ADV PAUSE STILL ADV
INDEX
Ð V
O L +
STOP INDEX
MULTI/
P-IN-P REC A.DUB
PLAY /REW FF/
ZOOM
REC
Camera or Remote control