Panasonic AG-HVX200 - Manual (Page 72)

72
Thumbnail operations (continued)
P2 card information screen
1 2
3
4
5
1 Write protection mark
2 P2 card status
The amount of memory remaining on the P2
card is displayed using a percentage bar. The
following displays may appear, depending on
the card status.
FORMAT ERROR:
An unformatted P2 card has been inserted.
NOT SUPPORTED:
A card not supported by the unit has been
inserted.
NO CARD:
A card has not been inserted.
• The information on the card in the selected
slot (indicated by the yellow number) can be
viewed by pressing the SET button.
BRAND: Name of manufacturer
MODEL NO.: Model number
SERIAL NO.: Serial number
USER ID: User ID
WARNING: Warning information
3 P2 card remaining memory/total memory
The P2 card’s remaining memory and total
memory are displayed here in 1-minute
increments. Fractions of a minute are rounded
off, meaning the display may not match the slot
total.
4 Card warning mark
This mark is displayed when one of the
following warnings applies to a P2 card.
1) RUN DOWN CARD (page 94)
2) DIR ENTRY NG CARD (page 94)
• The contents of the warning can be viewed by
checking the card information as described
above.
5 Slot total
The figure represents the total remaining
memory of the cards in the two slots. If a P2
card is write-protected, its remaining memory
will not be included in the total remaining
memory.
• When LOOP is set under REC FUNCTION,
the slot total represents the guaranteed
minimum recording time for loop recording.
However, note that when PROPERTY
SETUP: USED is selected in step 3 on the
previous page, the used amount displayed
by the slot total will be larger than the actual
amount, and when PROPERTY SETUP:
REMAIN is selected, the remaining amount
displayed by the slot total will be smaller than
the actual amount. (Page 50)
SD memory card information screen
!
THUMBNAIL
OPERATION
META DATA
EXIT
PROPERTY
SD STANDARD : : SUPPORTED
USED : 96 KB
TOTAL : 122.4 MB
NUMBER OF CLIPS :
PROTECT : OFF
BLANK : 122.3 MB
OK
SD STANDARD:
This indicates whether the SD memory card was
formatted in compliance with the SD or SDHC
standard. (SUPPORTED/NOT SUPPORTED).
USED: Space used
BLANK: Space available
TOTAL: Total space
NUMBER OF CLIPS: Number of clips
PROTECT:
This indicates that the SD memory card is write-
protected.
P2