Details of your projector (continued) – Panasonic TQBJ0323-1 User Manual
Page 14
Preparation
14 ENGLISH
Details of your projector (continued)
①
③
⑩
⑨
⑧
④
⑥
⑤
⑦
②
① Terminals
② Remote control signal receptor
③ AC IN
Connect the power cord to supply electric power to
the projector. ( page 20)
④ Air intake port
⑤ Front leg adjuster
To adjust the projection angle.
⑥ Rear leg adjuster
To adjust the projection angle. (
⑦ Burglar hook port
Attach a commercial burglar prevention cable.
⑧ Air outlet port
Hot air comes out from this opening.
⑨ Speaker
⑩ Lamp unit compartment ( page 48)
① Connect to a network cable.
(See “Network Operation Manual”.)
② Connect to a computer to control the projector’s
operation.
③ Connect to a computer or YP
B
P
R
signal cable.
④ Connect to an S-VIDEO signal cable.
⑤ Connect to a VIDEO signal cable.
⑥ Connect audio cables for inputting audio signal.
⑦ Connect an audio cable for audio signal output
to the connected equipment. If it is connected to
this terminal, no sound comes out of the built-in
speaker.
NOTE:
Do not place your hands or other objects close to the air outlet port as this may cause damage or injury.
•
Do not place your hands or face, or objects which cannot withstand heat near the air outlet port. Hot air comes out
•
from this port.
Rear and bottom view
Terminals
LAN
SERIAL
COMPUTER 1 IN
S-VIDEO
IN
VIDEO IN
AUDIO IN
1
2
AUDIO
OUT
COMPUTER 2 IN
①
②
③
④
⑤
⑥
⑦
NOTE:
Do not connect any power cable other than the attached one.
•
Do not cover the ventilation openings of the air intake port or air outlet port.
•