Connected to a wall outlet, Menu operation (continued) – Panasonic TQBJ0323-1 User Manual

Page 39

Advertising
background image

Settings

ENGLISH 39

Menu operation (continued)

NO SIGNAL SHUT-OFF

If no image signal is input for the time set using the

timer, the projector will automatically enter into standby

mode.

Change setting

Change

setting

Change

setting

Change setting

DISABLE NO SIGNAL SHUT-OFF is disabled

15 – 60

MIN.

Timer can be set at a 5-minute intervals

INITIAL START UP

You can set the starting method when the power plug is

connected to wall outlet.

Change setting

Change

setting

Change

setting

Change setting

LAST

MEMORY

Projector starts from the last image

before the power plug was disconnected

STANDBY Projector starts in the standby mode

ON

Projector starts immediately

INSTALLATION

When installing the projector, select the projection

method according to the projector’s position.

( page 17)

Change setting

Change

setting

Change

setting

Change setting

HIGH ALTITUDE MODE

If you use the projector at high elevation, the

HIGH

ALTITUDE MODE setting need to be ON to set the fan

speed to high.

Change setting

Change

setting

Change

setting

Change setting

OFF

Use in normal environment

(below 1 400 m (4 593 ft) above sea

level)

ON

Use at high altitude

(at 1 400 m – 2 700 m (4 593 - 8 858 ft)

above sea level)

NOTE:

The loudness of fan noise depends on the

HIGH

ALTITUDE MODE

setting.

STANDBY MODE

You can change the standby mode setting.

Change setting

Change

setting

Change

setting

Change setting

ECO

The standby power is reduced to 0.4 W

to save power

NORMAL

The power of the projector can be

turned

ON and the audio output can be

set active by controlling the computer

connected via wired LAN in standby

mode

LAMP POWER

You can adjust the power of the lamp to save electricity,

prolong the lamp life and reduce the noise.

Change setting

Change

setting

Change

setting

Change setting

NORMAL When higher luminance is required

ECO

When lower luminance is sufficient

NOTE:

This function is disabled when no input signal is detected.

ECO

setting is recommended when higher luminance is not

required such as in a small room.

Advertising