Panasonic TQBJ0323-1 - Manual (Page 32)

Settings
32  ENGLISH
Menu operation (continued)
▌ RGB/YP
B
P
R
(For RGB/YP
B
P
R
input signal only)
Select the signals to be input to the COMPUTER 1 IN
and COMPUTER 2 IN terminals.
Change setting
Change
setting
Change
setting
Change setting
AUTO Automatic adjustment
RGB For RGB signals
YP
B
P
R
For YP
B
P
R
signals
NOTE:
AUTO • mode is selected by default.
Select • RGB or YP
B
P
R
according to the input signal if the
image is not normally projected during AUTO mode.
The function only becomes effective when certain signals
are input:
(VGA60, 480i, 576i, 480p, 576p, 1 080/60i, 1 080/50i,
720/60p, 720/50p)
POSITION MENU
Remote control Control panel
MENU RETURN
ENTER
FREEZE
AV
MUTE
COMPUTER VIDEO
DEFAULT FUNCTION WIN. INDEX-
MENU
ENTER
DEFAULT
STANDBY
(R)
ON(G)
LAMP
TEMP
MENU FUNCTION
ENTER
INPUT
SELECT
MENU
ENTER
MENU RETURN
ENTER
FREEZE
AV
MUTE
COMPUTER VIDEO
DEFAULT FUNCTION WIN. INDEX-
MENU
ENTER
DEFAULT
STANDBY
(R)
ON(G)
LAMP
TEMP
MENU FUNCTION
ENTER
INPUT
SELECT
MENU
ENTER
Set the selected item with [].
▌ REALTIME KEYSTONE
If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled
surface; the keystone will be automatically corrected.
Change setting
Change
setting
Change
setting
Change setting
OFF Deactive
ON Active
NOTE:
If the detected tilt of the main unit is ± 5 %, even if you •
set ON, the distortion will not be corrected automatically.
Because the priority is not to correct the distortion, but to
avoid the image quality deteriorated by correcting.
If you need to correct the keystone, you can correct the •
distortion manually by adjusting the KEYSTONE.
▌ KEYSTONE
If you need to correct the angle of the projection even
when the REALTIME KEYSTONE is activated, you can
correct the keystone manually.
Image Operation
ENTER
ENTER
NOTE:
You can correct the distortion ±30 ° from the plane. •
For a better image quality, install the projector to minimize •
distortion.
The result of the keystone correction will affect the aspect •
ratio and the size of the image.
The image is distorted momentarily when the keystone is •
corrected.
▌ SHIFT
SHIFT H
V
0
0
Horizontal (H): Press [] to move the image
horizontally.
Vertical (V): Press [] to move the image
vertically.
NOTE:
This function can be adjusted by pressing the • 
buttons directly.
▌ DOT CLOCK
If there are interference patterns on the projected image
(referred as moire or noise), minimize it by pressing
[] to adjust the clock frequency. (For RGB (Still
image) input signal only)
NOTE:
DOT CLOCK • needs to be adjusted before adjusting the
CLOCK PHASE.