Panasonic TQBJ0323-1 - Manual (Page 31)

Settings
ENGLISH  31
Menu operation (continued)
▌ COLOR
You can adjust the color saturation of the projected
image. (For S-VIDEO/VIDEO/RGB (Moving image)/
YP
B
P
R
input signal only)
Lighter
Change
setting
Change
setting
Darker
▌ TINT
You can adjust the skin tone of the projected image.
(For S-VIDEO/VIDEO/RGB (Moving image)/YP
B
P
R
input signal only)
More reddish
Change
setting
Change
setting
More greenish
▌ SHARPNESS
You can adjust the sharpness of the projected image.
Less sharp
Change
setting
Change
setting
More sharp
NOTE:
The adjustable range depends on the input signal. •
▌ WHITE BALANCE
You can adjust the white balance in 3-color
temperature. (For RGB (Still image) input signal only)
-1
Change
setting
Change
setting
+1
Advanced menu item Default
WHITE BALANCE RED 0
WHITE BALANCE GREEN 0
WHITE BALANCE BLUE 0
▌ COLOR TEMPERATURE
You can adjust the white balance of the projected
image.
Change setting
Change
setting
Change
setting
Change setting
DEFAULT Balanced white
HIGH More bluish
LOW More reddish
▌ DAYLIGHT VIEW
You can keep the projected image bright and vivid even
in well-lit rooms where the ambient light sources cannot
be controlled.
Change setting
Change
setting
Change
setting
Change setting
AUTO Automatic adjustment
ON Active
OFF Deactive
NOTE:
Do not cover the Ambient Luminance Sensor(ALS) of the •
projector, otherwise the AUTO mode may not function
properly.
AUTO • is not available when INSTALLATION in
PROJECTOR SETUP menu is set to REAR/DESK or
REAR/CEILING.
▌ NOISE REDUCTION
You can switch the automatic noise reduction system
on/off. (For S-VIDEO/VIDEO input signal only)
Change setting
Change
setting
Change
setting
Change setting
OFF No noise reduction
ON Automatic noise reduction
NOTE:
If • NOISE REDUCTION is set active when the selected input
signal has less noise, the image may look different from the
true image. If so, set to OFF.
▌ TV-SYSTEM
Switch the setting manually to match the video data.
(For S-VIDEO/VIDEO input signal only)
Change setting
Change
setting
Change
setting
Change setting
AUTO NTSC NTSC4.43
SECAM PAL-N PAL-M PAL
NOTE:
AUTO • mode is selected by default.
When the projector is not working properly in • AUTO mode,
change the setting according to each TV system type.
AUTO • setting will automatically select the compatible
signal from NTSC/NTSC 4.43/PAL/PAL60/PAL-M/PAL-N/
SECAM.