National Instruments BNC -2140 - Manual (Page 40)

Index
BNC-2140 User Manual I-2 © National Instruments Corporation
analog output signal connections, 3-5
DGND signal, 68-pin connector signal
descriptions (table), 3-4
DIFF configuration
analog input circuitry, 4-3
analog input signal connections, 3-5
analog output, 4-4
analog output signal connections, 3-5
setting, 2-1 to 2-2
documentation
conventions used in the manual, viii
organization of manual, vii
related documentation, viii
dynamic signal acquisition boards, 1-1
E
electronic support services, B-1 to B-2
e-mail support, B-2
environment specifications, A-2
equipment, optional, 1-2 to 1-3
F
fax and telephone support numbers, B-2
Fax-on-Demand support, B-2
FTP support, B-1
fuse, self-resetting (table), 3-4
I
ICP
accelerometers and microphone
preamplifiers, 1-1, 4-3
configuring, 2-1 to 2-2
signal conditioning, 1-1, 4-3
installation
device configuration, 2-1 to 2-2
procedure, 2-1
unpacking the BNC-2140, 1-2
I/O connectors, 3-1 to 3-5
68-pin connector signal descriptions
(table), 3-4
analog connector signal descriptions
(table), 3-1 to 3-2
exceeding maximum ratings (caution),
3-4 to 3-5
pin connections (figure), 3-3
M
manual. See documentation.
O
operation of BNC-2140. See theory of
operation.
optional equipment, 1-2 to 1-3
P
physical specifications, A-2
pin connections
68-pin analog connector (figure), 3-3
mapping to DSA device (note), 3-4
power requirement specifications, A-2
R
requirements for getting started, 1-2
S
SE configuration
analog input circuitry, 4-3
analog input signal connections, 3-5
analog output, 4-4
analog output signal connections, 3-5
setting, 2-1 to 2-2
self-resetting fuse (table), 3-4