National Instruments RT Series - Manual (Page 13)

© National Instruments Corporation 2-1 RT Series DAQ Device User Manual
2
Installation and Configuration
This chapter explains how to install and configure your RT Series DAQ
hardware.
Installing the Hardware
You can install the RT Series DAQ device in any available expansion slot
in your computer or PXI chassis. To reduce noise, however, leave as much
room as possible between the RT Series DAQ device and other devices and
hardware. The following are general installation instructions. Refer to your
computer user manual or technical reference manual for specific
instructions and warnings about installing hardware.
Note Install LabVIEW Real-Time (RT) and NI-DAQ before you install your RT Series
DAQ device. Refer to Chapter 2, Installation, of the LabVIEW Real-Time User Manual for
information about installing LabVIEW RT and NI-DAQ.
PCI Installation
Complete the following steps to install your RT Series PCI device.
1. Turn off and unplug your computer.
2. Remove the cover to your computer.
3. Make sure there are no lighted LEDs on your motherboard. If any are
lit, wait until they go out before continuing your installation.
4. Remove the expansion slot cover on the back panel of the computer.
5. Insert the RT Series DAQ board into a 5 V PCI slot. Gently rock the
board to ease it into place. It might be a tight fit, but do not force the
board into place.
6. Screw the mounting bracket of the RT Series DAQ board to the back
panel rail of the computer.
7. Visually verify the installation. Make sure the board is not touching
other boards or components and is fully inserted in the slot.
8. Replace the cover.
9. Plug in and turn on your computer.