National Instruments RT Series - Manual (Page 35)

Index
RT Series DAQ Device User Manual I-2 ni.com
LabVIEW RT programming, 4-1 to 4-5
creating stand-alone executables,
4-2 to 4-3
downloading VIs, 4-1 to 4-2
LabVIEW functions not supported on
DAQ hardware, 4-3
real-time programming, 4-4 to 4-5
configuration issues, 4-4 to 4-5
running VI at time-critical
priority, 4-4
shared memory, 4-4
resetting RT Series DAQ device, 4-2
RT Series DAQ VIs, 4-5
targeting LabVIEW RT, 4-1 to 4-2
LabVIEW RT software
board configuration, 2-2 to 2-4
installing NI-DAQ, 1-3
LEDs, 3-5
M
manual. See documentation.
Measurement & Automation
Explorer, 2-2 to 2-4
N
NI Developer Zone, B-1
NI-DAQ software, 1-3
P
PCI devices. See also hardware overview.
installation, 2-1 to 2-2
PCI RT Series RT DAQ hardware
(figure), 3-1
physical specifications, A-2
power requirement specifications, A-2
processor board, 3-2 to 3-3
board diagram, 3-3
description, 3-2
specifications, A-1
programming. See LabVIEW RT
programming.
PXI devices. See also hardware overview.
installation, 2-2
PXI RT Series RT DAQ hardware
(figure), 3-2
R
real-time programming, 4-4 to 4-5
configuration issues, 4-4 to 4-5
running VI at time-critical priority
without RT Development System, 4-4
shared memory, 4-4
requirements for getting started, 1-2
resetting RT Series DAQ device, 4-2
RT Series DAQ devices. See also hardware
overview.
configuration, 2-2 to 2-4
device number, 2-3
devices and corresponding manual
(table), 1-2
installation, 2-1 to 2-2
overview, 1-1
programming. See LabVIEW RT
programming.
requirements for getting started, 1-2
software programming choices, 1-3
specifications, A-1 to A-2
unpacking, 1-3
RT Series DAQ VIs, 4-5
RTSI bus, 3-4 to 3-5