NordicTrack NTSY9897.0 - Manual (Page 6)

6
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two persons.
• Because of its weight and size, the resistance
system should be assembled in the location
where it will be used. Make sure that there is
enough clearance to walk around the resistance
system as you assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the resistance system, make
sure that all parts are oriented as shown in the
drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART on page 5.
The included hex keys and the following
tools (not included) may be required for assembly:
• two adjustable wrenches
• one Phillips screwdriver
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
Everything in this manual is designed to ensure
that the resistance system can be assembled
successfully by almost anyone. By setting aside
plenty of time, assembly will go smoothly.
1.
Insert the two Base Legs (2) into the Base (1)
as far as possible. With the help of a second
person, carefully tip the resistance system onto
its left or right side.
Attach one of the Base Legs (2) to the Base (1)
with two M10 x 20mm Button Screws (59);
do
not tighten the Button Screws yet.
Attach the Left Base Cover (20) to the Base (1)
with an M4 x 12mm Self-tapping Screw (77)
and an M5 Large Washer (63).
Repeat this step on the other side of the
resistance system.
Before beginning assembly, make sure
that you understand the information in
the box above. For help identifying small
parts, see the PART IDENTIFICATION
CHART on page 5.
59
20
63
77
1
2
2
1