Nikon S1200PJ - Manual (Page 200)

E 82
Refe
rence S
e
cti
o
n
Error Messages
The following table lists the error messages and other warnings displayed in the
monitor, as well as the solutions for dealing with them.
Display Description Solution
A
O (blinks) Clock not set. Set date and time. E 61
N
Battery exhausted.
Battery exhausted. Charge or replace the battery. 16, 18
P
Battery temperature
high
Battery temperature is
high.
Turn off camera, and allow
battery to cool down before
resuming use. After five
seconds, the monitor will turn
off and the power-on lamp
will blink rapidly. After the
lamps blink for three minutes,
the camera will turn off
automatically. Pressing the
power switch also turns off
the camera.
23
P
The camera will turn
off to prevent
overheating.
The camera has become
hot.
The camera turns off
automatically. Leave the
camera off until it has cooled
and then turn it on again.
81
N
No signal. The
camera will turn off.
There is no signal from
the connected device. Input a signal from the
connected device.
81
P
Close the projector
cover
The projector cover is
opened.
• Close the projector cover
• To resume projection, close
the projector cover, turn
the camera off and back on,
and open the projector
cover.
81
Q ( ● blinks red)
Camera cannot focus.
• Refocus.
• Use focus lock. 28, 31
68
P
Please wait for the
camera to finish
recording.
Camera cannot perform
other operations until
recording is complete. Wait until message clears
from display automatically
when recording is complete.
–
N
Memory card is
write protected.
Write-protect switch is
in “lock” position. Slide write-protect switch to
“write” position.
–