Nokia MOBILE PHONE N86 - Manual (Page 36)

White balance ( ) — Select the current lighting
condition. This allows the camera to reproduce colours
more accurately.
Exposure compensation ( ) (image only) — If you are
shooting a dark subject against a very light background,
such as snow, adjust the exposure to +1 or +2 to
compensate for the background brightness. For light
subjects against a dark background, use -1 or -2.
Sharpness ( ) (image only) — Adjust the sharpness of
the image.
Contrast ( ) (image only) — Adjust the difference
between the lightest and darkest parts of the image.
Light sensitivity ( ) (image only) — Increase the light
sensitivity in low light conditions to avoid too dark
images.
The screen display changes to match the settings you
make.
The available settings vary depending on the selected
camera.
The setup settings are shooting-mode specific. Switching
between the modes does not reset the defined settings.
The setup settings return to the default settings when you
close the camera.
If you select a new scene, the colour and lighting settings
are replaced by the selected scene. You can change the
setup settings after selecting a scene if needed.
Video settings
To change the main settings, in the video mode, select
Options > Settings and from the following:
Video quality — Set the quality of the video clip. Select
Sharing , if you want to send the video clip using a
multimedia message. The clip is recorded with QCIF
resolution, in 3GPP format, and the size is limited to 300
kB (approximately 30 seconds). You may not be able to
send video clips saved in the MPEG-4 format in a
multimedia message.
Record location — To add GPS location coordinates to
each file, select On . Receiving the GPS signal may take time
or the signal may not be available.
Video stabilisation — Reduce the effects of the camera
shaking when recording a video.
Audio recording — Select whether to record sound.
Add to album — Add the recorded video clip to an album
in Photos.
Show captured video — Select to view the first frame of
the recorded video clip after the recording stops. To view
the entire video clip, select Play from the active toolbar
(main camera) or Options > Play (secondary camera).
Default video name — Enter the default name for
captured video clips.
Memory in use — Select where you want to store your
video clips.
Restore camera settings — Restore the camera settings
to default values.
36
Ca
mera