National Instruments CAN 372139B-01 - Manual (Page 102)

Chapter 5 Automotive Diagnostic Command Set API for LabVIEW
Automotive Diagnostic Command Set User Manual 5-76 ni.com
WriteMemoryByAddress.vi
Purpose
Executes the WriteMemoryByAddress service. Writes data to the ECU memory.
Format
Input
data in defines the memory block to be written to the ECU.
diag ref in specifies the diagnostic session handle, obtained from Open
Diagnostic.vi and wired through subsequent diagnostic VIs. Normally, it is
not necessary to manually manipulate the elements of this cluster.
address defines the memory address to which data are written. Notice that
only three bytes are sent to the ECU, so the address must be in the range
0–FFFFFF (hex).
size defines the length of the memory block to be written.
error in is a cluster that describes error conditions occurring before the VI
executes. If an error has already occurred, the VI returns the value of the
error in cluster to error out.
status is TRUE if an error occurred. This VI is not executed when
status is TRUE.
code is the error code number identifying an error. A value of 0
means success. A negative value means error: the VI did not
execute the intended operation. A positive value means warning:
the VI executed intended operation, but an informational warning
is returned. For a description of the code, wire the error cluster to
a LabVIEW error-handling VI, such as the Simple Error
Handler.
source identifies the VI where the error occurred.