National Instruments CAN 372139B-01 - Manual (Page 111)

Chapter 5 Automotive Diagnostic Command Set API for LabVIEW
© National Instruments Corporation 5-85 Automotive Diagnostic Command Set User Manual
UDS DiagnosticSessionControl.vi
Purpose
Executes the UDS DiagnosticSessionControl service. Sets up the ECU in a specific diagnostic
mode.
Format
Input
diag ref in specifies the diagnostic session handle, obtained from Open
Diagnostic.vi and wired through subsequent diagnostic VIs. Normally, it is
not necessary to manually manipulate the elements of this cluster.
mode indicates the diagnostic mode into which the ECU is brought. The
values are application specific. The usual values are:
01: defaultSession
02: ECUProgrammingSession
03: ECUExtendedDiagnosticSession
error in is a cluster that describes error conditions occurring before the VI
executes. If an error has already occurred, the VI returns the value of the
error in cluster to error out.
status is TRUE if an error occurred. This VI is not executed when
status is TRUE.
code is the error code number identifying an error. A value of 0
means success. A negative value means error: the VI did not
execute the intended operation. A positive value means warning:
the VI executed intended operation, but an informational warning
is returned. For a description of the code, wire the error cluster to
a LabVIEW error-handling VI, such as the Simple Error
Handler.
source identifies the VI where the error occurred.