Network Computing Devices NCDWare 9300572 Rev. B - Manual (Page 16)

15
Installing NCDware on WinCenter Systems
The procedure in this section is required for NT -only networks. If
your NCD network computers (also called terminals) are on an
NT -only network, you need to install NCD ware on a WinCenter
server so it can act as a boot server for the NCD terminals.
The instructions below describe how to install NCD ware on a
WinCenter server running WinFrame 1.6 or later. For information
about WinCenter, see WinCenter product documentation. For
additional information about using and configuring
NCD ware, see
NCD ware documentation.
Using setup
To install NCD ware you need:
❏ A WinCenter server equipped with a CD-ROM drive and running
WinFrame 1.6 or later
❏ Approximately 10 minutes for the installation
Note For information on space requirements, see the Release
Notes or the file
SIZES on the CD-ROM .