Network Computing Devices NCDWare 9300572 Rev. B - Manual (Page 17)

16
To install NCD ware:
1. Place the NCD ware CD-ROM in the CD-ROM drive.
2. To run setup, choose one of the following:
❏ From the menu bar, select File
⇒
Run. Then type
d:\WINNT\setup and press Return (where d is the
CD-ROM drive).
or
❏ Double click on the File Manager and select the CD-ROM
drive. Select \WINNT\setup.exe from the files listed.
The NCD ware License Agreement appears.
3. Read the license agreement and select Yes to accept the license
terms.
If you select
No , the Exit Setup dialog box appears. Select
Resume to go back to the license agreement. Select Exit
Setup to quit.
4. The Select Components dialog box appears, listing the
components you can install. The default selection, Prepare
System Services , installs the file transfer software ( TFTP ) and
the address discovery services ( BOOTP ) needed for NCD ware.
Note Throughout the installation procedure a selected item is
designated by a box with an
x inside. Click on the box to
clear the selection or click on an empty box to select an
item.