NordicTrack NTSA03990 - Manual (Page 10)

10
16. Wrap the High Cable (73) around a 4” Pulley (35) in
the direction shown and attach the Pulley to the Top
Frame (1) with a 3/8” x 2 1/2” Bolt (54), two 3/8” Flat
Washers (55), two 5/8” x 1/2” Pulley Bushings (42),
and a 3/8” Nylon Locknut (63).
16
17. Thread the 1/2” Plain Nut (68) part way onto the bolt
at the end of the High Cable (73).
Place the 1 1/2” Flat Washer (40) on top of the
Weight Tube (36) and the Long Bushing (76).
Tighten the bolt at the end of the High Cable (73) into
the threaded hole in the Weight Tube (36).
When all Cables (73, 72 [not shown], 133 [not shown])
are tight, tighten the 1/2” Plain Nut (68) onto the 1 1/2”
Flat Washer (40).
Go to the Seat And Plate Assembly section on
page 12 and continue with step 18.
17
73
63
42
73
35 42
55
1
68
40
76
36
54
55