NordicTrack NTSA03990 - Manual (Page 8)

8
10. Wrap the Cable (133) around a 4” Pulley (113) and
attach the Pulley and a Cable Trap (116) to the Press
Frame (101) with a 3/8” x 3 3/4” Bolt (110), a 3/8”
Washer (120), and a 3/8” Nylon Locknut (118).
Make sure that the Cable (133) is routed in the
direction shown.
11. Slide the end of the Cable (133) between the 4”
Pulley (113) and the Cable Trap (116) assembled in
step one.
9. Wrap the Cable (133) around a 4” Pulley (113) and
attach the Pulley and a Cable Trap (116) to the Rear
Press Upright (104) with a 3/8” x 3 3/4” Bolt (110), a
3/8” Washer (120), and a 3/8” Nylon Locknut (118).
Make sure that the Cable (133) is routed in the
direction shown.
9
120
116
104
113
133
118
10
116
101
133
120
110
118
11
133
113
116
8. Open the parts bag labeled “CABLE ASSEMBLY.”
Attach the Cable (133) to the indicated hole in the
Press Base (101) with a 3/8” x 3” Bolt (117), two 3/8”
Washers (120), a 5/8” x 1/4” Spacer (127), and a 3/8”
Nylon Jam Nut (122).
Note: Do not over tighten the
Jam Nut; the Cable must be able to pivot easily.
8
120
120
133
127
101
122
117
Cable Assembly
110
113