NordicTrack NTSA03990 - Manual (Page 7)

7
4. Slide the Press Frame (102) into the Seat Frame
(106).
Press a 2” Square Inner Cap (112) into the indicated
end of the Press Frame (102). Press a 2” Square
Angled Cap (126) onto the other end of the Press
Frame.
Note: Make sure the Support Plate (135 [not
shown]) is inside the 2” Square Angled Cap (126).
6
124
Lubricate
104
105
101
118
7. Lubricate two 3/8” x 3 1/4” Bolts (124). Attach the
Press Plates (108) to the Rear and Forward Press
Uprights (104, 105) with the Bolts and two 3/8” Jam
Nuts (122).
Do not over tighten the Bolts; the Press Uprights
must be able to pivot freely.
7
124
108
108
104
105
6. Lubricate two 3/8” x 3 1/4” Bolts (124). Attach the
Rear and Forward Press Uprights (104, 105) to the
Press Base (101) with the Bolts and two 3/8” Nylon
Locknuts (118).
Note: the Rear Press Upright has
an extra hole halfway down the side.
Press two 2” Square Inner Caps (112) into the Rear
and Forward Press Uprights (104, 105).
Do not over tighten the Bolts; the Press Uprights
must be able to pivot freely.
4
129
126
102
106
112
5. Attach the Seat Frame (106) to the Press Base (101)
with four 3/8” x 3” Carriage Bolts (115) and four 3/8”
Nylon Locknuts (118).
5
115
118
106
101
115
118
112
122
Lubricate