NordicTrack NTSA03990 - Manual (Page 5)

5
Assembly
Make sure you have the following tools:
• Two adjustable wrenches
• One rubber mallet
• You will also need grease or petroleum jelly, a
small amount of soapy water, and clear tape or
masking tape.
Note: Assembly will be more convenient if you have
a socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
How to Identify Parts
To help you identify the small parts used in assembly,
we have included a PART IDENTIFICATION CHART
on page 4. Use the chart to easily identify parts dur-
ing each assembly step.
Note: Some small parts
may have been pre-attached. If a part is not in
the parts bag, check to see if it has been pre-
attached.
Select a Location
Because of its weight and size, the leg press acces-
sory should be assembled in the location where it
will be used. Make sure that there is enough room to
walk around the training system as you assemble it.
Tightening Parts
Tighten all parts as you assemble them, unless
instructed to do otherwise.
Questions?
If you have questions after reading the assembly
instructions, please call our Customer Service
Department toll-free at
1-888-825-2588 Monday
through Friday, 6 a.m. until 6 p.m. Mountain Time.
Assembly Requires Two Persons
For your convenience and safety, assemble the leg
press accessory with the help of another person.
Set Aside Enough Time
Due to the many features of the leg press accesso-
ry, the assembly process will require a few hours.
By setting aside plenty of time and by deciding to
make the task enjoyable, assembly will go smoothly.
How to Orient Parts
As you assemble the leg press accessory, make
sure that all parts are oriented exactly as shown in
the drawings.
How to Unpack the Box
To make assembly as easy as possible, we have
divided the assembly process into three stages.
The parts needed for each stage are found in indi-
vidual bags.
Important: Wait until you begin each
stage to open the parts bag for that stage. Place
all parts of the leg press accessory in a cleared
area and remove the packing materials. Do not dis-
pose of the packing materials until assembly is com-
pleted.
Make Assembly Easier for Yourself!
Everything in this manual is designed to
ensure that the leg press accessory can be
assembled successfully by anyone.
Before
beginning assembly, make sure to read the
information on this page; this brief intro-
duction will save you much more time than
it takes to read it!