NordicTrack NTSA03990 - Manual (Page 9)

9
13. Locate the Pulley Bracket (91), one 1/4” Flat Washer
(71), and one 1/4” Nylon Locknut (25) that came with
your weight system. Attach the end of the Cable (133)
to the Pulley Bracket with the Flat Washer and the
Nylon Locknut.
13
71
25 91
133
12. Wrap the Cable (133) around a 4” Pulley (113) and
attach the Pulley and a Cable Trap (116) to the weld-
ed bracket on the stabilizer with a 3/8” x 2” Bolt (121)
and a 3/8” Nylon Locknut (118).
IMPORTANT:
If you are assembling the leg
press accessory at the same time as your weight
system, continue with Assembly Option A, below.
If your weight system is already assembled, contin-
ue with Assembly Option B, on page 11.
Note: At this point you will begin using parts from
both the leg press accessory and your weight sys-
tem. Pay attention to key numbers as they will cor-
respond to two different part lists.
12
118
133
113
121
14. Install the High Cable (73) to the point indicated
as instructed in your weight system manual.
Substitute the following steps for those in the
manual to complete the installation of the High
Cable.
Wrap the High Cable (73) around a 4” Pulley (35) and
attach the Pulley and a Cable Trap (44) to the top
hole in the Pulley Bracket (91) with a 3/8” x 1 3/4”
Bolt (60) and a 3/8” Nylon Locknut (63).
15. Wrap the High Cable (73) around a 4” Pulley (35) in
the direction shown and attach the Pulley to the Top
Frame (1) with a 3/8” x 2 1/2” Bolt (54), two 3/8” Flat
Washers (55), two 5/8” x 1/2” Pulley Bushings (42),
and a 3/8” Nylon Locknut (63).
14
15
44
63
73
60
73
1
35 63
55
55
54
42
91
35
Assembly Option A
116
Bracket