Nikon WT-2 - Manual (Page 11)

4
Step 1—Connect the WT-2
1 Turn the camera off.
4 Open the camera USB connector cover and con-
nect the USB cable to the USB connector.
LOCK
POWER POWER
5 Pass the cable over the guide on the BL-2 battery-
chamber cover.
LOCK
POWER POWER
3 Place the camera on the WT-2 and rotate the knob
in the direction shown to fasten the WT-2 to the
camera tripod mount.
LOCK
POWER
LINK BUSY
POWER
LINK BUSY
2 Remove the cover protecting the camera power
contact. The cover can be stored in the housing
on the WT-2.
Disconnecting the WT-2
To disconnect the WT-2:
1 Turn the camera off.
2 Disconnect the USB cable.
3 Rotate the knob clockwise to unscrew the WT-2 from the camera tripod mount.
4 Replace the cover on the camera power contact.
Setup