Nikon WT-2 - Manual (Page 57)

50
Troubleshooting
Problem Solution
“POWER” LED does not light.
• Turn camera on.
• Press shutter-release button halfway to acti-
vate exposure meters.
• Select On for Wireless LAN > Wireless
LAN system option in camera setup menu.
• Reattach WT-2.
5
—
24
4
All LEDs blink at once.
WT-2 hardware error. Contact a Nikon-autho-
rized service representative.
—
Wireless LAN option not avail-
able in camera setup menu. Select PTP for USB option in camera setup
menu.
5
Excessive radio interference. Change orientation of camera or antenna. —
Camera displays wireless, TCP /
IP, or FTP error.
Check settings for host and / or wireless LAN
adapter and adjust camera settings appropri-
ately.
26
28
32
Can not connect to ftp server.
Check settings for server and / or wireless LAN
adapter and adjust camera settings as described
in “Sample ftp Settings.”
42
Transfer interrupted before all
photographs are sent.
Transfer will resume if camera is turned off and
then on again, exposure meters are reactivated,
or On for Wireless LAN > Wireless LAN sys-
tem option in camera setup menu.
11