National Instruments NI 1450 Series - Manual (Page 23)

Chapter 2 Setup and Configuration
© National Instruments Corporation 2-9 NI 1450 Series Compact Vision System User Manual
If your camera requires an external power supply, connect it to the
camera and verify that the camera is powered on.
3. Plug in and power on the monitor.
Figure 2-2. Basic Hardware Setup
Wiring Power to the NI 1450
This section describes how to connect the NI desktop power supply.
For instructions on how to connect a separate main supply, refer to the
Connecting to a Separate Main Supply section.
Caution Do not connect the NI 1450 main power to a source other than 24 VDC ±10%.
Do not connect the NI 1450 isolated power to a source less than 5 VDC or greater than
30 VDC. Doing so could damage the NI 1450.
To connect power to the NI 1450, refer to Figure 2-3 while completing the
following steps:
1. Plug the 4-position connector from the power supply into the power
receptacle on the NI 1450.
2. Plug the power cord into the power supply.
3. Plug the power cord into an outlet.
1 VGA Cable 2 IEEE 1394 Cable
2
1