Figure 2-4. ethernet connection, Re 2-4 – National Instruments NI 1450 Series User Manual
Page 26
Chapter 2
Setup and Configuration
NI 1450 Series Compact Vision System User Manual
2-12
ni.com
Figure 2-4. Ethernet Connection
Vision Builder AI: Setting up the Development Computer
This section describes the sequence for installing Vision Builder AI and the
NI-IMAQ for IEEE 1394 Cameras software on the development computer,
obtaining an IP address, installing software on the NI 1450, and
configuring the NI 1450 to acquire an image using Vision Builder AI.
This section applies only to Vision Builder AI users. If you are using
LabVIEW RT with the Vision Development Module, refer to the
Real-Time with the Vision Development Module: Setting up the
Development Computer
section.
1
Standard Ethernet Cable Connecting from the NI 1450 to an Ethernet Hub
2
Standard Ethernet Cable Connecting from an Ethernet Hub to the Development Computer
3
Ethernet Hub or Other Network Port
3
1
2