Numark Industries CDN90 - Manual (Page 5)

CDN90
SETUP & CONNECTIONS
Typical connection with a mixer is illustrated below.
1. Mount the units in your console or rack with 19” EIA rails.
2. The transport should be mounted not to exceed an angle of 15 degrees.
3. Your CD player can be affected by excess vibration so mount the units in a secure
environment if possible.
4. Connect the supplied Control Cables between the CD Remote and CD Transport unit.
Note: Be careful to attach the marked connection jacks together, (yellow –yellow and
black-black)
5. Connect the line output connections using the supplied audio cables from the CD
Player to the line inputs of your mixer.
6. Connect Fader start cable. Attach your CD play to a similarly equipped DJ mixer.
(This connection can also be used with a remote switch)
7. Connect IEC power cord to appropriate power source. For US and Canada be sure to
use Polarized power cord and outlets.
- The Leader in DJ Technology
©2002 Numark Industries - 5 - http://www.numark.com