NetComm 5 Port Gigabit Switch NP3005 - Manual (Page 13)

Rev.1 - YML671 www.netcomm.com.au
NP3005 - 5 Port Gigabit Switch Page 13
Preparation before connecting your switch
Before you install your switch, make sure you will be operating the unit within the specified
voltage and temperature limits. To install your switch on a flat surface, simply adhere the
included rubber feet within the outlines on the bottom surface of the unit. Ensure the switch is
positioned with at least 50mm of space on all sides for adequate ventilation.
To install the switch on a wall, measure the distance between the mounting holes on the back of
the switch and mark the wall to match the measured distance. At the marked location, screw into
the wall two suitably sized screws.
Choose a location that is near the devices to be connected, is close to a suitable electrical outlet,
and provides at least 50mm of space all around the switch for ventilation.