NorthStar Navigation Explorer 660 - Manual (Page 45)

Northstar Explorer 660 Installation and Operation Manual 45
13 User card display
A C-MAP™ user card is an optional plug-in card
that can store data files (see section 1-2). There
are three types of files: waypoints, routes or a
track.
To go to the user card display, press DISPLAY,
select Other, then select User card.
Note: The older 5 volt cards are not supported.
The user card display has:
File list
A list of the files on any user card in the Explorer
660. If there are more files than will fit on
the display, press
or to scroll up or
down a page at a time.
Waypts, Routes
The number of waypoints and routes
currently in the Explorer 660.
Track 1 to Track 5
The number of points in tracks 1 to 5
currently in the Explorer 660.
Note:
To save Explorer 660 data onto the user card, use
the Save command (see below).
Data stored on the user card and shown on the
fi le list is not available to be used by the Explorer
660 until loaded into the Explorer 660 with the
LOAD command (see below).
Saving data to the user card
This saves all the Explorer 660’s waypoints, all the
Explorer 660’s routes or one of the Explorer 660’s
tracks to one file on the user card.
1 Press MENU and select Save.
2 Select Waypts, Routes or Tracks.
3 For Tracks, select the track number to save.
4 The new file is created. Change the name if
required. The new file appears in the file list.
Loading data from the user card to the
Explorer 660
This loads one file from the user card to the
Explorer 660:
A waypoints file: The new waypoints are
added to any existing waypoints in the
Explorer 660. If a new waypoint has the
same name as an existing waypoint but has
different data, the Explorer 660 displays both
waypoints. Select:
Skip: Do not load the new waypoint.
Replace: Load the new waypoint and
replace the existing one.
Skip all: Do not load any new
waypoints which have the same names
as existing waypoints.
Rplc. all: Load all new waypoints
which have the same names as existing
waypoints; the new waypoints replace
the existing waypoints.