NorthStar Navigation Explorer 660 - Manual (Page 47)

Northstar Explorer 660 Installation and Operation Manual 47
Press MENU once or more until the Setup menu
is displayed, then select System:
Language
Select the language for the displays. The options
are: English, Italian, French, German, Spanish,
Dutch, Swedish, Portuguese, Finnish and Greek.
Tip: In case you can’t read the current language, the
language setting is found at the top of the system
menu.
Backlight
The backlight control is displayed. The bar setting
represents the current level of backlighting.
Key beep
Enables or disables the beep when a key is pressed.
Auto power off
Select On to have the Explorer 660 power off
automatically every time the boat’s ignition is
switched off. This applies only if the display unit
is wired for Auto Power. See section 6-5 Wiring
Options.
15-1 Setup > System
Factory reset
This option returns all of the Explorer 660 settings
(except the language) to the default factory
settings shown on the next page.
A warning box asks: Are you sure? Select
Yes and press ENTER to confirm.
Instant display changing
Controls how the display changes when you
press the DISPLAY key and use the display menu
to choose a new display (see section 2-6). The
options are:
Off: The display only changes when you
press finally ENTER to choose a display..
On: The display changes each time you
highlight another display in the display menu.
Sonar
Disable any sonar transducer and disable
sonar functions.
A sonar transducer is fitted. Enable
sonar operation.
SmartCraft
No SmartCraft gateway is fitted. Disable
SmartCraft functions.
SmartCraft gateway is fitted. Enable
SmartCraft operation.
Buddy track
No DSC VHF radio is fitted. Disable Buddy
track.
A DSC VHF radio is fitted. Enable Buddy
track.
15 Setting up the Explorer 660
The Explorer 660 has a number of advanced
features which are set up through the setup
menu. We recommend that you become familiar
with the operation of the unit using the default
settings before making any changes to the data
in these menus.
Press MENU one or more times, to show the
Setup menu, then select a particular option
using the
or cursor keys. (Section 2
describes how to use the keys in more detail.)
The Setup menu and options are summarized
on the next page. The factory default settings
are shown where applicable.
Each Setup menu option is explained in the
following sections.