Gps antenna, Sonar transducer – NorthStar Navigation Explorer 660 User Manual

Page 64

Advertising
background image

Northstar Explorer 660 Installation and Operation Manual

64

GPS antenna

Fit the GPS antenna (see section 7) and install the
antenna cable back to the Explorer 660. Follow
the instructions in the manual supplied with the
antenna. Connect the antenna to the Explorer
660:

The cable on the GPS antenna supplied has
a plug with a yellow collar. Plug this into the
connector on the back of the Explorer 660
with a yellow nut. Tighten the locking collar.

If the GPS source is NavBus or NMEA, see
section 16-6.

Sonar transducer

Either:

Fit the transom mount sonar transducer
supplied, following the instructions in the
Transom Mount Transducer Installation
Manual supplied with the Explorer 660.

For enhanced performance, fit an optional
through hull dual frequency sonar transducer
and through hull speed/temperature
transducer. Contact the nearest Northstar
dealer for more information.

The sonar transducer cable has a plug with a blue
collar. Plug this into the connector with a blue nut
on the back of the Explorer 660. Turn the collar to
lock the connector.

16-4 Mounting the GPS antenna and transducers

Optional fuel kit

1

Fit the optional fuel kit following the
instructions supplied with the kit.

Note: If the NMEA input on the fuel sensor
cable is used, then a Northstar special fuel
cable is required (see section 16-6).

2

Wire the Explorer 660 for auto power (see
section 16-5)

3

The fuel sensor cable has a plug with a white
collar. Plug this plug into the connector with
a white nut on the back of the Explorer 660.
Turn the collar to lock the connector.

Advertising