NorthStar Navigation Explorer 660 - Manual (Page 55)

Northstar Explorer 660 Installation and Operation Manual 55
15-7 Setup > Logs
Press MENU one or more times until the Setup
menu is displayed, then select Logs: The values can be changed independently of
each other. These log values are saved when the
unit is turned off.
Reset trip dist
This resets the trip distance to zero.
Reset total dist
This option resets the total distance to zero.
Reset engine hours
Use this option to reset the engine hours to zero. This
can be useful after an engine service or to count the
engine hours between service intervals.
15-6 Setup > Track
Press MENU one or more times until the Setup
menu is displayed, then select Track:
Tracking records and displays the boat’s course
on the chart (see section 3-6). Five different tracks
can be recorded: track 1 has up to 2000 points
and tracks 2, 3, 4 and 5 have up to 500 points
each.
Record
Off: The Explorer 660 stops recording
a track.
1 to 5 (select a track number): The Explorer
660 starts recording the boat’s course into
the selected track.
Display
Off: No track is shown on the chart.
1 to 5 (select a track number): The
selected track is shown on the chart.
Plotting Interval
The options are Distance or Time.
Distance
Select the distance plotting interval: 0.01, 0.05, 0.1,
0.5, 1.0, 2.0, 5.0 or 10.0 distance units.
Time
Select the time plotting interval: 1, 5, 10 or 30
seconds or 1 minute.
Memory used
The percentage of memory used in the track
being recorded.
Tip: Use the user card display to check the
number of points recorded in each track (see
section 13).
Send track
This option is included for compatibility with
older units. For information, see your Northstar
dealer.
Delete track
The data in the track selected for Record (see
above) is deleted.