NETGEAR 700 Series Managed Switch for Software v2.1 - Manual (Page 105)

700 Series Managed Switch User’s Guide for Software v2.1
Command Line Interface 6-15
SM-10004-02
<duplex operation> = one of three modes. auto, full, or half.
Exit
This command takes you out of Interface Configuration Mode and back to Configuration Mode.
Syntax
FSM726(config-if)# exit
Flow Control
This command enables flow control on this particular port.
Syntax
FSM726(config-if)# flow-ctrl
Help
The help command displays instructions on how to access help on the CLI.
Syntax
FSM726(config-if)# Help
To access Help on a specific command, you enter a question mark behind the command in
question, then a list of available options will be presented to you. For example, suppose you want
to know the available options to the command
cos . You would enter cos ?.
Mirror
You can designate a port for monitoring traffic from one or more other ports or of a single VLAN
configured on the switch. The switch monitors the network activity by copying all traffic from the
specified monitoring sources to the designated monitoring port, to which a network analyzer can
be attached
Syntax
FSM726(config-if)# mirror [source | monitor]
Where
[source | monitor] = Setting this particular port to be a mirror source or a mirror monitor