NETGEAR 700 Series Managed Switch for Software v2.1 - Manual (Page 118)

700 Series Managed Switch User’s Guide for Software v2.1
6-28 Command Line Interface
SM-10004-02
Syntax
FSM726(config)# system gateway <default gateway>
Where
<default gateway> = the IP address of the default gateway
Save
The save command is used to save the configuration to the ’s NVRAM once you have made
changes to it.
Syntax
FSM726(config)# system save
Restore
The restore command is used to restore all configurations back to factory default value. Please
note that this command will cause the switch to reset itself.
Syntax
FSM726(config)# system restore
Web
Use this command enable/disable the web configuration interface. Use the No command to disable
the web interface.
Syntax
FSM726(config)# system web
Telnet
Use this command to enable/disable configuration via telnet. Use the No command to disable the
Telnet access.
Syntax
FSM726(config)# system telnet