NETGEAR 700 Series Managed Switch for Software v2.1 - Manual (Page 106)

700 Series Managed Switch User’s Guide for Software v2.1
6-16 Command Line Interface
SM-10004-02
Use the no command to disable mirror.
Negotiation
This command lets you enable speed and duplex auto-negotiation.
Syntax
FSM726(config-if)# negotiation auto
No
The No command negates one of your previously given commands.
Syntax
FSM726(config-if)# no <commands>
Where
<command> = the command which you wish to negate.
For example, suppose you previously turned on flow control on this particular interface by using
the
flow-ctrl command, and you changed your mind and wish to turn it off. The command to do
so would be
no flow-ctrl
Another example:
Suppose you have configured this particular interface to e a mirror source with the mirror source
command. To disable the port as a port mirror, use the no mirror source command.
Type
The type command let you select whether to use the RJ-45 interface or the GBIC interface on your
gigabit ports (port 25 & 26). If a GBIC module is present, you may wish to use gbic mode;
however, if no GBIC module is present, the switch defaults to the RJ-45, also known as
twisted-pair (TP).
Syntax
FSM726(config-if)# type <interface type>